Reported by Al Jazeera
Thousands of routers used in communications systems are slated to be replaced, raising the risk of more problems.
A group of Democratic Senators has asked the United States Federal Aviation Administration (FAA) to pause its plan to replace thousands of routers until an investigation is completed into why one such upgrade caused a national ground stop last week.
“With thousands of conversions remaining, FAA must address outstanding safety and reliability concerns before expanding installation,” the 13 senators wrote in a letter to the agency on Tuesday.
More from the original report
The FAA ordered all flights to remain grounded on Friday for about four hours, causing more than 10,000 flights to be cancelled and prompting ripple effects that continue to disrupt air travel in the US. It was only the second time the agency had issued such a sweeping order since the September 11, 2001 attacks.
The FAA said in a statement on Sunday that its initial investigation pointed to upgrades at two locations – a radar site in Amarillo, Texas, and a radio communications site in El Dorado, Arkansas – as being the cause of the problem.
L3Harris, the agency’s network service provider, had been working to replace old copper wires with fibre-optic lines and to replace old routers with new ones made by Juniper Networks.
The FBI said on Tuesday that it was working with the Department of Transportation, the FAA, and L3Harris to investigate the incident, but had not taken possession of any equipment itself.
In their letter to the FAA, the group of senators asked the agency to halt plans to replace more than 3,000 additional routers.
“Based on information provided to our offices from L3Harris, the copper-to-fibre transition involves converting 3,648 routers to Juniper devices. To date, it is our understanding that 400 devices have been installed, and 69 are operational,” wrote the lawmakers from the Senate Commerce Committee, led by Maria Cantwell.
On Sunday, the FAA said the upgrades had started a long time ago.
“This type of work has been going on for years to transition from old copper wires that are being disconnected due to their obsolescence,”…
